How to make a mini paper santa hat

know how to sew, turn the trim right-side-out and slide it over the bottom airplane edge of the trim. Because of how short the ends of the fur trim are, you shouldn't have to use sewing pins. It will be faster to do this on a sewing machine, but you can do it by hand. Cut another matching slit on the right side of the circle, also 12 inch (1.3 cm) from the edge. 18 Don't use white pompoms; they won't give you the right look. Red construction paper, pencil, scissors, white construction paper, glue. Slide the hat around on the headband into your desired position. For example, if you want it to be 2 inches (5.1 cm) wide, then cut it 2 inches (5.1 cm) wide. In this section we are going. Once you are happy with the fit, take the hat off. Tacky glue or white school glue will work just fine for this, but you can use a hot glue gun too. Wrap a measuring tape around the base of your cone to get the circumference, then cut a strip of white fur according to that measurement. Make the fur strip about 12 to 1 inch (1.3.5 cm) wide. The smaller, round piece should be glued at the top point of the hat, and the longer piece should be glued along the bottom edge of the paper. You can make it sit right on top of the headband or at a slight angle.

The westport smaller the hat will turn out. Use red sparkly felt for a fancier touch. If you use tacky financ glue or fabric glue.

Festive, paper, hats For The Holidays 3 Cute Diy.Mini, paper, tops Hats 144x144jpg.

Fleece, quickly press the edge back against the cone. Decide where you want the tip of a3 a4 b4 b5 paper the hat to hang. Velvet, tacky glue, then use that measurement for the height. And hold it there until the glue sets.

You can do this with hot glue, fabric glue, or tacky glue.Because 1 of the diagonal edges is already along the fold, you only need to add seam allowances to the bottom curved edge and the other diagonal edge.